Problems to build Dalton-2016 under FreeBSD-amd64: error in gptrygve

[edulsa]

Dear

I was able to compile Dalton-2011 under FreeBSD a long time ago without many problems. But now, I experienced issues trying to build dalton.x:

[ 66%] Building Fortran object CMakeFiles/dalton.dir/DALTON/gp/gptrygve.F.o
*** Error code 1

Stop.
make[2]: stopped in /home/edulsa/Downloads/Dalton/dalton/build
*** Error code 1

Stop.
make[1]: stopped in /home/edulsa/Downloads/Dalton/dalton/build
*** Error code 1

Stop.
make: stopped in /home/edulsa/Downloads/Dalton/dalton/build


More specifically:

/home/edulsa/Downloads/Dalton/dalton/DALTON/gp/gptrygve.F:509:2:

>>>>> insert appropriate OPEN statements in OPENDX.
1
Error: Non-numeric character in statement label at (1)
/home/edulsa/Downloads/Dalton/dalton/DALTON/gp/gptrygve.F:509:3:

>>>>> insert appropriate OPEN statements in OPENDX.
1
Error: Invalid character in name at (1)
*** Error code 1

Stop.
make[2]: stopped in /home/edulsa/Downloads/Dalton/dalton/build
*** Error code 1

Stop.
make[1]: stopped in /home/edulsa/Downloads/Dalton/dalton/build
*** Error code 1

Stop.

At line 509, there is only:

>>>>> insert appropriate OPEN statements in OPENDX.


Please, could you give some hint to solve this?

My setup is: gfortran7 / gcc7 /g++7 compilers as fortrancompiler, ccompiler and cmakecompiler, my mathlib is atlas

Another important point: I could build lsdalton without problems in the same machine.

Thank you in advance

My best regards

Eduardo

[magnus]

Perhaps try to delete that line and the one before and after. It does not look like it is important but don't know for sure. If it compiles and tests complete successfully it should be fine.

[edulsa]

Dear Magnus

Thank you.
After deleting that line, I could have dalton compiled. Now, I will make tests to be assured it is ok.

My best wishes

Eduardo

[magnus]

That's good! I wonder if the tests were completed successfully?